Grimmspeed Mazdaspeed Electronic Boost Controller Manuel d'utilisateur télécharger pdf (Page 10)

Grimmspeed

1. You will be installing the GrimmSpeed solenoid on the firewall above the turbo. You will

be using the existing two factory studs. Place the provided rubber washer on the left stud

and the rubber grommet on the right. Install solenoid on studs. Using the provided nylon

locking nuts, tighten bracket.

2. Follow MazdaSpeed 3 instructions starting at Step 8.

F. External Wastegate(EWG) Installation

Hook up vacuum lines. See Figure 3. Port 3 connects to a high-pressure boost source (there is

a vacuum nipple on the turbo compressor outlet). Port 2 connects to the bottom port on the

external wastegate. The factory restrictor pill should be removed for operation. It is

recommended that a plastic zip tie is used to secure vacuum lines. The electrical is plug and

play with the supplied connector.

1 2 ... 5 6 7 8 9 10 11

Pas de commentaire

Grimmspeed Mazdaspeed Electronic Boost Controller Manuel d'utilisateur Page 10