Grimmspeed Alternator Cover Manuel d'utilisateur télécharger pdf

GrimmSpeed Install Guide Series

Installing the GrimmSpeed Subaru Alternator Cover

Updated 11/20/13

Introduction: This guide will illustrate the installation of the GrimmSpeed

Alternator Cover. The difficulty here is super low, so take your time and enjoy the

job!

Tools: The tools listed below are suggested for this task (figure 1). Optional tools

are noted.

- 10mm socket and accompanying ratchet

- 12mm socket (if you need to install the OEM bracket)

- 5mm Allen Wrench

Figure 1: Tools

Tips: Use care to not drop the anodized spacers into your engine bay, but if you do,

don’t burn yourself while you reach for them!

Procedure:

1. Begin by collecting your tools and popping your hood. This’ll be quick!

10mm socket/ratchet

5mm Allen

1 2 3 4

GrimmSpeed Install Guide Series Installing the GrimmSpeed Subaru Alternator Cover Updated 11/20/13 Introduction: This guide will illustrate the inst

2. Now, remove your factory alternator cover if you still have it in place. This will require a 10mm socket to remove the two fasteners securing it.

Short Bolt  Small Washer  Cover  Short Standoff  Large Washer  Factory Bracket  Nut Get the nut started, but do not tighten all the way, you’ll

5. Next, use the longer bolt and the smaller washer to assemble the passenger side as shown. Bolt  Small Washer  Cover  Long Standoff  Factory

Pas de commentaire

Grimmspeed Alternator Cover Manuel d'utilisateur